产品特点：

1、取出照明车上层箱体内光源，固定光源并链接至照明车输出端插座

Take out the light source inside the upper box of the lighting car, fix the light source and link the output end socket of the lighting car;

2、伸拉输入端电源线至220V电源处并连接电源插座，给照明车供电；

Pull the input power cord to 220V power supply and link the power socket to supply power to the lighting vehicle

3、打开照明车220V电源开关，指示灯亮起，确认照明车通电正常；

Turn on the 220V power switch of the lighting car, and the indicator light is on to confirm that the lighting car is powered on normally;

4、依次打开照明车输出端36V电源开关，同时亮起对应电源的指示灯

Turn on the 36V power supply switch at the output end of the lighting vehicle in turn, and light up the indicator light of the corresponding power supply

5、一个36V输出回路最多连接10套光源，严禁超负荷运转。

A 36V output circuit shall be connected to 10 sets of light sources at most, and overload operation is strictly prohibited.

关闭照明车：首先依次关闭照明车输出端电源、输入端电源，同时相应指示灯熄灭，再收起光源并放置光源箱，最后收起输入端电源；

First, turn off the power supply at the output terminal and the input terminal of the lighting vehicle in turn, and the corresponding indicator light is off, then pack away the light source and place the light source box, and finally pack away the power supply at the input terminal;